ST Model Beaver RTF

Features
    - Good-natured flight characteristics
    - Servo-controlled landing flaps
    - Optional float kit for water flight
    - LED position lights and landing lights
    - Incl. floats

Technical data
- Wingspan: approx. 1520 mm
- Length: approx. 965 mm
- Weight: approx. 1150 g
- Type of drive: E-motor

RC functions
- aileron
- Elevator
- Rudder
- Throttle
- Flaps

Description
The first flight of the light transport aircraft Beaver took place in Canada at the end of the 1940s. Within a very short time, the Beaver became the "bush plane" par excellence. Because of the possibility to equip the plane with wheels, floats or skis, there was no corner of the world where this plane could not land.
The successful replica of the ST Model Beaver in EPO foam has, like the original, extremely good-natured flight characteristics. The uncritical take-off and landing behaviour, even in somewhat stronger wind conditions, allow the pilot to quickly become familiar and confident with the model. The servo-controlled landing flaps additionally support the slow flight characteristics.
Optionally, the model can be equipped with floats, article no. A-STM140FL for water flight.

Included in delivery
    - Fuselage, wing and tail unit made of EPO foam with paint and applied decal sheet
    - 5 micro-servos, built-in
    - BL outrunner, installed
    - BL-regulator 40A, installed
    - propeller
    - spinner
    - Dummy cowl
    - Robust bipod landing gear
    - Steerable tail wheel
    - Wheels
    - Attachment points for optional float kit
    - LED position lights and landing lights
    - Various small parts
    - Instruction manual
    - Float

Recommended accessories:
Remote control: Gavin 6A or 6C
Receiver: MSR66A 6-channel
Battery: Torcster 2200 3s 11,1V
Charger: Torcster 80W
Torcster superglue ULTRA thick 20g
Torcster activator spray for superglue 150ml
Torcster LiPo Safe Box L or XXL

Note: When using Torcster LiPos, the adapter no. 210177 MPX male to T-Plug female adapter is required.