The charger which is fun to use ... Power Peak Fun.

A reasonably priced, high-performance charging/discharging station with battery management, suitable for charging batteries consisting of 1 ... 24 NC / NiMH cells and 1...6 Lithium / Li-Po cells. The charger´s wide charge current range of 0.1 to 6.5 A makes it suitable for small slow-fly models, transmitter and receiver batteries, and also for large drive batteries and flight packs. Especially important for short charge times when using high-capacity Li-Po batteries. Safe and simple to use; automatic storing of essential individual battery data using the robbe BID system.

BID system stands for Battery IDentification System.
A small, lightweight BID chip is assigned to each battery; the chip stores all the relevant data for charging and discharging that pack perfectly. When the battery is to be charged or discharged, the BID chip and the battery are connected to the Power Peak Fun charger, and the BID system informs the charger of the required parameters. Press the Start button, and the charge or discharge process begins.

The special advantages of the BID system are as follows:
- No tiresome searching through menus for the set-up parameters
- Maximum protection from mis-handling
- Storing of the relevant battery data in the BID chip. The BID chip is so small and
  light (0.5 g) that it can be attached to the battery itself,
  or fitted inside the heat-shrink sleeve.
- A BID chip with a 300 mm lead is supplied with the charger.
- Naturally the Power Peak Fun charger can also charge batteries without
   the BID system.
- In addition to the BID system, high charge currents and a broad cell-count range
   this charging station offers the following functions:
           -> Charge
           -> Discharge
           -> 1 ... 3 x discharge - charge
           -> Display of charge time, capacity, peak voltage, input voltage,
                average voltage, charge voltage, energy, discharge current,
                charge current and time.
           -> Display and storing of the last five discharged and charged-in
                capacity values.
           -> Setting of charge current and discharge current.

NC/NiMH-batteries
1 ... 24 cells
An automatic digital Delta Peak charge termination (cut-off) circuit switches off the charge process at the correct time; the circuit is designed to suit NC and NiMH batteries.

Lithium / Li-Po batteries
1 ... 6 cells
Automatic charge termination circuit which switches off the charge process at a final charge voltage of 4.2 Volts per cell. If the charger is connected to the Power Peak SPS 7A mains PSU, No. 8415, it can also be operated from the 230 Volt mains supply. In this case the maximum currents are restricted with high cell-count batteries.

Specification:
Input voltage: 11-15V
Charge termination: automatisch
Trickle charge: 80 mA
Dimensions: 140x108x52 mm
Charge current: 0.1-6.5 A
No. of NC cells: 1-24